HOT TUB CLEANER.jpg

Jetline Cleaner

$19.56

For use before draining.

Loosens minor buildup in the plumbing system. Use between draining cycles, or as a system purge prior to draining.

For use before draining.

Loosens minor buildup in the plumbing system. Use between draining cycles, or as a system purge prior to draining.

KEEP OUT OF REACH OF CHILDREN.

  • Supplier:

    Phoenix Products Company 

    55 Container Drive 

    Terryville, CT 06786 

    (860) 589-7502 

    Emergency Telephone: U.S. PERS Emergency Telephone 1-800-633-8253 

  • Chemical Name: Sodium Metasilicate

    CAS Number: 6834-92-0

     % By Weight: 2 - 5 

    Ingredients listed in this section have been determined to be hazardous as defined in 29 CFR 1910.1200. Materials determined to be health hazards are listed if they comprise 0.1% or more of the composition. Information on proprietary materials is available in 29CFR 1910.1200 (i) (1). 

  • Chemical Name: Sodium Metasilicate 

    Trade names: Jet Line Cleaner 

    Chemical Family: N/A 

    Product Description: Clear to Amber Liquid 

    Type of product and use: Alkali Base Detergent, a blend of surfactants, quaternary amine compounds, alkali builders. 

  • SKIN CONTACT: Wash with soap and water. If irritation develops, call a physician. 

    EYE CONTACT: Immediately flush with large quantities of water, holding eyelids open. Seek medical attention immediately. 

    INHALATION: Get to fresh air. Seek medical attention if irritation persists. 

    INGESTION: Do not induce vomiting. Drink large quantities of water. See medical attention immediately. 

  • BOILING POINT .................. >212 ° F 

    VAPOR PRESSURE: .......... +20MM Hg@68 F. 

    % VOLATILE ...................... 85+ 

    SOLUBILITY in WATER...... Complete 

    VAPOR DENSITY………………(AIR=1) <1 

    EVAPORATION RATE........ (WATER=1) :< 1 

    SPECIAL Firefighting Procedures: Non Flammable 

    PHYSICAL DESCRIPTION: Clear to Amber Liquid – Mild Odor 

  • PERSONAL PROTECTIVE EQUIPMENT: See Section 8 (Personal Protective Equipment) 

    ENVIRONMENTAL PRECAUTIONS: None Known 

    METHODS FOR CLEANING UP: Contain large spills and pump to recover. Small spills can be mopped up and recovered. Absorb spill with inert material (e.g. sand, vermiculite). Collect and dispose contaminated area should be neutralized using dilute acid. 

  • SAFE HANDLING RECOMMENDATIONS: Eye irritant. May cause skin irritation with prolong or repeated contact. Avoid contact with eyes, skin and clothing. Wear rubber gloves, chemical splash goggles and protective outerwear when handling. Avoid breathing of mists. Keep out of reach of children. 

    VENTILATION: Normal ventilation should be sufficient under normal conditions. 

    SAFE STORAGE RECOMMENDATIONS: Store in cool, dry place. Keep containers tightly closed. Container closed when not in use; Keep out of Reach of Children. Use safe chemical handling procedures suitable for the hazards presented by this material. 

    INCOMPATIBLE MATERIALS: Acids, some metals 

  • ENGINEERING CONTROLS: General ventilation. 

    PERSONAL PROTECTIVE EQUIPMENT (PPE) 

    • EYE/FACE PROTECTION: Splash goggles or safety glasses are recommended. 

    • SKIN PROTECTION: Chemical resistant clothing is recommended to minimize potential irritation from handling. 

    • HAND PROTECTION: Chemical resistant gloves are recommended to minimize potential irritation from handling. 

    • RESPIRATORY PROTECTION: None required where adequate ventilation conditions exist. 

    • GOOD HYGIENE /WORK PRACTICES: Always follow good hygiene/work practices by avoiding vapors or mists and contact with eyes and skin. Thoroughly wash hands after handling and before eating or drinking. Always wear the appropriate PPE when repairing or performing maintenance on contaminated equipment. Wear protective rubber footwear when using on floor. Wear protective outerwear when danger of mist contact may occur. 

  • Appearance..................... Clear to amber 

    Physical State .............. Liquid 

    Vapor Density .............. Not available 

    Flash Point ………………. >212 ° F 

    Boiling Point................. 212°F 

    Solubility ...................... Soluble 

    pH Factor .................... <2.0 

    Specific Gravity………………1.086 

    NOTE: These physical data are typical values based on material tested but may vary from sample to sample. Values should not be construed as a guaranteed analysis of any specific lot or as specifications. 

  • STABILITY: This product is stable under normal conditions 

    POLYMERIZATION: Hazardous polymerization will not occur under normal conditions 

    HAZARDOUS DECOMPOSITION PRODUCTS: Alkaline vapors in a fire. 

    INCOMPATIBLE MATERIALS: Strong Oxidizers or strong bases. Acids 

  • WASTE DISPOSAL: Reuse or recycle if possible. Dispose in accordance with all applicable regulations. Consult state and local regulations regarding the proper disposal of this material. 

    CONTAINER: Nonrefillable container. Do not refill or reuse this container. Triple rinse or equivalent before discarding in trash. 

    NOTE: Chemical Additions, processing or otherwise altering this material may make the waste management information presented in this MSDS incomplete, inaccurate or otherwise inappropriate. 

  • FIFRA: N/A 

    SARA Title III 

    HMIS Identification system 

    • Health 2 

    • Flammability 0 

    • Reactivity 0 

    • Personal Protection C 

  • No representations or warranties, either expressed or implied, of merchant ability, fitness for a particular purpose or any other nature are made hereunder with respect to information or the product to which the information refers.